Most times when I hear an alarm (presumably for fire) go off in the office or a public place, it goes as such:

  1. Observe for any signs of actual emergency: smoke, smell, flame, first responders, or panicking crowds
  2. If nothing unusual seen and nobody is getting up, assume it’s a false alarm and continue with task at hand
  3. (Most of the time) Alarm was false and goes away within a few minutes
  4. (<1% of the time) There is indeed a fire somewhere in the building and people take their time gathering belongings before leisurely walking to the nearest door

Same goes in the house:

  1. Wake up groggy, assume false alarm again
  2. Put on pants, check out the source of the noise
  3. (4 times in current residence) Find no indication of fire, hush alarm
  4. Alarm shuts up with a dose of compressed air. If not, sledgehammer time and buy a new one the next day.

That can’t be how most of us are supposed to go about it, right?

Is it for a lack of better smoke detection technology? A consequence of buying low-quality detectors? While we’re at it, can anyone recommend a smoke detector that does its job with a minimum of false alarms?

  • jake_jake_jake_@lemmy.world
    link
    fedilink
    arrow-up
    4
    ·
    2 days ago

    It may have been a rate of rise vs a hard upper limit for the heat detector. If it was, about 8-10°C / 15-20°F change per minute would set it off. Makes sense for it to go off over an oven. The hard upper limit type are single use, I don’t know if that causes them to repeatedly go off or not.

    Either way with more regulated short term rentals, a fire inspection would likely have flagged that.